Ri Function Settings - Onkyo A-9130 Mode D'emploi

RI function settings

1
2
3
(CD)
Linked D1
Linked LINE IN 1
(Tuner)
Linked D2
Linked LINE IN 2
SETUP
When connecting an Onkyo CD player or tuner to the RI
REMOTE CONTROL jack on this unit (p11) and using the
RI function, you need to make RI function settings.
1. Press SETUP on the remote controller.
0 If this unit is set to be used as a power amplifier, the
SETUP button will not work. Check the setting. (p19)
2. Press D/C on the remote controller several times to
switch to the RI function setting mode.
0 When connecting a CD player, make it so that one of the
"D1" and "LINE 1" indicators blinks and the other one
lights.
(BLINKING)
0 When connecting a tuner, make it so that one of the "D2"
and "LINE 2" indicators blinks and the other one lights.
(BLINKING)
3. Press B/A on the remote controller to switch the setting.
(When connecting a CD player)
- When connecting to the DIGITAL IN COAXIAL D1 jack
(default value): The "D1" indicator blinks and "LINE 1"
lights.
- When connecting to the LINE IN 1 jack: The "LINE 1"
indicator blinks and "D1" lights.
(When connecting a tuner)
- When connecting to the DIGITAL IN OPTICAL D2 jack
(default value): The "D2" indicator blinks and "LINE 2"
lights.
- When connecting to the LINE IN 2 jack: The "LINE 2"
indicator blinks and "D2" lights.
4. To exit the settings, press SETUP.
0 The setting mode ends after 5 seconds elapse with no
operations performed.
Preparations
/ / /
(LIGHTING)
(LIGHTING)
15
En