Mounting The Flight Controller; Mounting The Motor Cowl - Reely SKY X-Ray Notice D'emploi

h) Mounting the Flight Controller
Figure 7, item 1 shows a possible installation site of
the flight controller. The assembly must be selected
individually according to flight controller used.
Figure 7, item 2 shows the assembly site of the
rechargeable battery. The later installation and
fastening must be performed individually with hook-and-
loop tapes.
Figure 7
i) Mounting the Motor Cowl
Adjust the motor cowl and transfer to the spinner at
your own discretion depending on motor. Independently
of this, observe matching cooling of the drive.
The motor cowl is attached to the bottom of the fuselage
with two grub screws 2 x 6 mm each on the left and
right and with a screw. Pre-drill the corresponding small
holes in the motor carrier for this.
The motor cowl must be installed so that the distance
of the spinner back plate to the motor cowl is approx.
2 - 3 mm.
Practical advice:
To be able to drill the perfectly matching holes for the
screws of the motor cowl, attach two paper strips to
Figure 8a
the left and right of the fuselage with adhesive tape
with the motor cowl removed (figure 8a, item 1).
The paper strips must be attached so that the holes to
be drilled at the motor carrier can be marked on the
paper strips.
Then fold the paper strips back again, apply the motor
cowl and mark the drill holes at the motor cowl as
indicated on the paper strips.
Figure 8b
34