WOLFF VARIO-STRIPPER 230 V Traduction Du Mode D'emploi Original page 20

EN
5.0 Transport
To avoid injury, the knife must be removed when transport-
ing the machine. Before removing the handle, fi rst remove
the mains plug from the socket.
5.1 Carrying belt
To carry the machine, the provided carrying belts will be
fi xed at the 4 brackets (13) fi g.A.
6.0 Maintenance
Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
The machine must then be sent to an after-sales
Service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for WOLFF
power tools.
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine.
6.1 Changing the driving wheels fi g. D
Remove the splint-pins (4) and pull the wheels (3) from
the axle (1). Do not loose the keyes (2) under any circums-
tances!
6.2 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
20 20
7.0 Trouble shooting
Fault Possible cause
The machine Power supply
does not start interrupted
Defective cable
Defective plug
Higher exer- Blade is
tion of force blunt
required while
working
high vibration
Wear parts of the
machine are knocked
out
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable
must be collected separately and disposed of in an envi-
ronmentally correct manner.
Subject to change without notice
9.0 Notes on various fl oor cover-
ings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The VARIO-STRIPPER is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched fl oor cover-
ing and carpeted fl ooring.
Remedy
Contact
Electrician
For repair and
/or replace parts
Change blade
Return machi-
ne for service
and/or repair