fig. 25 control panel - operating condition
4.16
CHANGING THE ROOM TEMPERATURE
SETTING
To change the room temperature, just act on the keys (1) and
(2). The display shows the current status of the temperature
setting, fig. 26.
1
2
fig. 26 control panel - room temperature modification
4.17
USING THE EXTERNAL THERMOSTAT/
CHRONOTHERMOSTAT
It is possible to connect an external thermostat to the stove
for remote management of some functions.
•
external thermostat: set a temperature of 7°C.
•
external chronothermostat: set temperature of 7°C and
from the menu "03 Set chrono -> 01 enable chrono" disable
the chrono function (off).
The stove is enabled when it is on and the contact
is closed. The external thermostat must be con-
nected by the Authorised Assistance Centre.
EN
EN
4.18
ROOM TEMPERATURE REACHES THE SET
TEMPERATURE
When the room temperature or the flue gas temperature have
reached the set value, the heat output is automatically
brought to the minimum value "MODULATION" condition, see
fig. 27.
fig. 27 control panel - set temperature modulation
If STANDBY mode is activated, the stove switches off with a
delay equal to the time preset by the manufacturer after hav-
ing reached the set temperature.
The stove restarts after the room temperature
drops below the set temperature for an amount
of time preset by the manufacturer.T
4.19
CLEANING THE BRAZIER
During standard operating conditions, the "BRAZIER CLEAN-
ING" mode is activated at intervals established by the manu-
20
facturer for a preset amount of time.
fig. 28 control panel - brazier cleaning mode
4.20
SWITCH-OFF
To switch the stove off, just press the button (4) for about 2
seconds. The auger stops immediately and the flue gas extrac-
tor is brought to high speed. "FINAL CLEANING" is carried out.
When the flue gas temperature has dropped to a value set by
the manufacturer, the flue gas extractor is disabled after a pre-
set amount of time.
4.21
RESTART
The stove cannot be restarted until the flue gas temperature
drops below the preset value for the set amount of time.
Always clean the brazier before restarting.
fig. 31 control panel - cooling wait before restart
4.22
FUNCTIONS OF MECHANICAL AND
ELECTRIC COMPONENTS
Auger motor
The auger motor drives the screw
which brings pellets from the tank
to the brazier.
< T
.
room
set
translated from the original text
Instructions for use
fig. 29 control panel - final cleaning
fig. 30 control panel - switch-off
Mod. CINEA CANALIZÁVEL
4
rev 00