Installation Instructions; Camera Unit System - weewell WMV820 Mode D'emploi

Placement Type
Raise the hanging buckle (as shown in Figure 3) and then
rotate the lock to fix it.

Installation Instructions

Camera Unit System

1. Connect one end of the transformer to the the
camera unit system (as shown in Figure 4) and con-
nect the other end of the transformer to the power
supply.
2. Press ON/OFF button to start the camera unit sys-
tem.
Placement Type
Stand Type:
Wall Mount Type: Fix a screw into the wall and leave a distance of about
Magic Belt Type:
Stand Type
The stand can be placed on 4 angles (i.e., front, rear,
right and left). adjust the desired angle and position.
8-9mm away from the wall. Hang the camera unit
system.
Put the magic belt through the camera unit system
base and tie it to the cylinder (Note: it cannot be tied
to the crib).
Magic Belt Type
Figure 3
Figure 4
Wall Mount Type
WMV820 USER MANUAL
I
5