Troubleshooting; Fcc Statement - weewell WMV820 Mode D'emploi

Troubleshooting

If you are not getting any signal at all :
• Make sure the camera and the monitor are turned on.
• Make sure the power plugs are pushed all the way in.
• Check that the channel on the camera and the monitor are set to the same number.
If you have seen the opening screen, but nothing appears afterwards.
• Please check if your Camera unit is turned on. The green Power LED will light up
and indicate the system is on.
• Make sure the Camera unit and Monitor Unit are within the appropriate range
of each other. For trouble shooting purpose, you should remove all the obstacles
between the two devices. Try a shorter distance.
• Please remove the battery and unplug the A/C adapter. Wait for 10 minutes.
• Plug the A/C adapter back to the Monitor Unit and retry to power on the Monitor
Unit.
If all above steps fail, you are advised to pair the Monitor Unit and Camera
Unit.
• Please following the steps mentioned in Pairing/New Added Camera Unit.
• If you would like to return to the default settings, press and hold [ ], meanwhile
push on/off, and then press [ ]. The setting will be restored.

FCC Statement

WARNING: Modifications not authorized by the manufacturer may void
user´s authority to operate this
device.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on ,
WMV820 USER MANUAL
I
11