Exit [ ]; Pairing/Newly-Added Camera Unit System - weewell WMV820 Mode D'emploi

Exit [ ]

Press [ ] Exit to come out from the main menu. Press [
or to exit . Press [ ] to directly exit and return to the monitoring screen.

Pairing/Newly-added Camera unit System

Note: The monitor unit system and camera unit system have been paired
when they are delivered from the factory. Under normal circumstances, it is
not recommended to re-pair them.
The system can support up to 4 camera units. The operations for adding a
camera unit system are as follows:
1. Turn off the monitor unit and the camera unit.
2. Press and hold [
will appear as follows:
3. Press [ ] and [ ] buttons located at the right side of the camera unit at the
same time for 2 seconds and release after the indicator lights up.
4. Press the arrow keys to select Ch2 and Pair, press [ ] The following screen will
appear:
Press OK button to back Menu
Press [ ] again, Ch2 Paired will appear in the monitor screen. This means that
the CH2 has been successfully paired. See below picture:
Press EXIT and press [ ] once more to return to the screen of the monitor unit.
5. Repeat steps 1-4 to pair Ch3 and Ch4.
10 I
WMV820 USER MANUAL
], meanwhile, push the ON/OFF button. The pairing list screen
Status
Press Up/Down button to select channel
Press Left/Right button to set
Press Ok button to entry
CH1 Pair Del
CH2 Pair Del
CH2 Pair Del
CH2 Pair Del
Exit
Pairing succeed Ch2 is selected
Pairing succeed Ch2 is selected
Press OK button to back Menu
Press Up/Down button to select channel
Press Left/Right button to set
Press Ok button to entry
CH1 Pair Del
CH2 Pair Del
CH2 Pair Del
CH2 Pair Del
Exit
] to select Yes or No
Status
Paired
Null
Null
Null
Status
Paired
Paired
Null
Null