Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before using the air conditioner, check:
- That it has been installed according to safety instructions
- That it is not damaged or broken
- That the electrical socket that you wish to use has the same voltage as
is given on the unit's specification plate (220-240V / 50Hz)
- That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket.
The control panel en the remote control have basically the same buttons.
Insert 2 batteries (AAA-1.5V) in the battery compartment at the back on the
remote control.
•
Switch the device on using the Power button. The display shows the last
set temperature.
1. Cooling function
•
Press on Mode until the Cool light shows
•
Set the desired temperature using the Temp+(Up)/Temp-(Down) button.
•
The display shows the set temperature. The temperature can be set to
between 17 and 30°C.
•
Maintain an interval of at least 3 minutes between each on and off.
2. Dehumidifying function
•
Press on Mode until the Dry light shows
•
Display shows 'DH'.
•
Check that the water outlet is correctly connected.
•
The display automatically shows 2°C under room temperature.
•
The temperature cannot be changed.
•
The fan speed is set to low automatically.
•
Maintain an interval of at least 3 minutes between each on and off.
3. Heating function
•
Press on Mode until the Heat light shows
•
Set the desired temperature using the Temp+(Up)/Temp-(Down) button.
•
The display shows the set temperature. The temperature can be set to
between 17 and 30°C.
•
Maintain an interval of at least 3 minutes between each on and off.
on the display.
on the display.
on the display.
3 7
Publicité
Chapitres
Table des Matières
