Publicité
Les langues disponibles
Les langues disponibles
Maintenance Manual
2.2 Installation not matching the regulations, stan-
dards and good practice, including:
• New safety valve missing or not installed according to standard EN 1487 or modi-
fication to the setting, hydraulic system directly installed on the water heater that
prevents the safety unit from working (pressure reducing valve, stop valve, etc.)
• No couplings (cast iron, steel or insulating) on the hot water connection pipes,
which could cause corrosion.
• Faulty electrical connections: not to standard NFC 15100, incorrectly earthed,
insufficiently thick cable, connection using flexible cables, failure to comply with
the manufacturer's wiring diagrams.
• Appliance not positioned as shown in the instructions.
• Abnormal tapping corrosion (hot or cold water) due to a faulty connection (bad
seal) or faulty dielectric coupling (direct iron/copper contact).
• Electrical protective cover missing or badly installed.
• Cable entry missing or badly installed.
• Fall of an appliance due to inappropriate attachment points.
2.3 Defective maintenance
• Abnormal scale deposits on the elements or safety devices.
• No maintenance of the safety system leading to excess pressure.
• Modification of the original equipment without the maker's approval or use of
spares not approved by him.
3. After-sales department
The parts of the water heater that can be replaced are as follows:
• Door seal
• Electronic thermostat assembly
• Heating element
• Sheath for ceramic element
• safety / control probe
• battery
Only use spare parts referenced by Atlantic.
To order, please specify the exact code and serial number of the water heater
(inset) indicated on the appliance's identification plate placed near the electrical
equipment.
All work on the product should be performed by a specialist.
57
57
Publicité
Chapitres
