Technical Specifications - Hendi 225165 Mode D'emploi

be damaged. Failure to observe this prohibition invalidates any responsibility of
the manufacturer of the machine.
• The appliance is intended for professional use and must be utilised by qualifi ed
personnel trained to use it.
• Any modifi cation which may be necessary on the electrical system to enable in-
stallation of the appliance, must be carried out solely by competent personnel.
• It is dangerous to modify or attempt to modify the characteristics of this appliance.
• Never clean the appliance with direct water jets, because, if any water enters, it
could limit the machine's safety.
• Before doing any maintenance or cleaning jobs, disconnect the appliance from
the electrical mains and allow it to cool.
• Do not attempt to carry out the periodic controls or any repairs by yourself. Con-
tact the nearest Service Centre and use only original spare parts.
• When the tilting door is wide open, do not put anything on the surface, because
the door hinges could be irreparably damaged.
• N.B.: Improper or incorrect use and failure to observe the installation instruc-
tions shall release the manufacture from all responsibility. In this connection,
the directives in the "POSITIONING" paragraph must be strictly observed.

3. TECHNICAL SPECIFICATIONS

Model
Dimensions of appliance
Weight of appliance
Max absorted power
Convection heating element
Grill heating element
Top and bottom heater
Power supply voltage
Appliance class
Power cable diameter
Type of cable
Electric cable connection
The noise level of the appliance in operation is below 70 dB (A).
The "technical data" plate is positioned on the rear panel of the appliance.
The manufacturer and dealer is not liable for any
inaccuracies due to printing errors or transcrip-
tion, in this manual. In line with our policy of con-
tinuous improvement products, we reserve the
225165
590x695x(H)590 mm
36,4 kg
2,6 kW
2,5 kW
1,9 kW
2,3 kW
230 V / 50 Hz
I
3x1,5 mm²
H07RN-F
Type Y
right to make modification of the product, pack-
aging and specifications contained in the Docu-
mentation without prior notice.
EN
5