Technical Assistance; Wiring Layouts - Hendi 225165 Mode D'emploi

Fig. 4

11. TECHNICAL ASSISTANCE

Before leaving the factory, the appliance was com-
pletely regulated and tested by expert specialised
personnel to guarantee the best operating results.
All repairs and settings must be performed with ut-
most care and attention, respecting national safety

12. WIRING LAYOUTS

EN
M Power supply terminal board
Pr "End of cooking" programmer
T1 Safety thermostat
T2 Oven thermostat
C Oven switch
S1 Programmer indicator light
S2 Thermostat indicator light
12
Fig. 5
regulations in force. Always contact your retailer
or our nearest Service Centre, giving details of the
problem, the appliance model and the serial num-
ber (on the rating plate on the rear panel).
L Oven lighting lamp
R1 Grill heating-element
R2 Circular heating-element
R3 Bottom heating-element
R4 Top heating-element
V1 Radial motorised ventilator
V2 Tangential motorised ventilator
Fig. 6