Télécharger Imprimer la page

Technical Specifications; Instructions For The Installer - Hendi 225516 Mode D'emploi

Masquer les pouces Voir aussi pour 225516:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48

3. TECHNICAL SPECIFICATIONS

Dimensions of appliance LxDxH (mm)
Weight (Kg)
Convection heating element (kW)
Max. absorbed power (kW)
Power supply voltage (V)
Power cable diameter
Type of cable
Connecting electric cable
Class
Degree of protection against humidity
Water pressure (kPa)
The noise level of the appliance in operation is below 70 dB (A).
The II technical data II plate is positioned on the rear panel of the appliance.

4. INSTRUCTIONS FOR THE INSTALLER

The following instructions are aimed at the quali-
EN
fi ed installer, to ensure that he carries out the in-
stallation, adjustment and maintenance operations
as correctly as possible and according to current
legal regulations. Any operation must be per-
formed with electrical power cut to the appliance.
4.1 POSITIONING
Position the appliance perfectly horizontally on a ta-
ble or similar support (the table or support must
be at least 85 cm above the fl oor). Position it at a
distance of not less than 10 cm from the side and
rear walls, to enable natural ventilating air to cir-
culate freely around it. The appliance is ventilated
through specifi c openings on the metal walls of the
outer housing, and ensures effi ciency and long-life.
For this reason it is strictly forbidden to obstruct
4
790x750x635
50,4
3,0
3,4
230V ~50/60Hz
3x1,5 mm2
H07RN-F
TipoY
I
IPX3
100-200
Before using the appliance, carefully remove the
special adhesive fi lm protecting the parts in stain-
less steel. Do not leave any glue residues on the
surfaces. If necessary, remove them at once, with
an appropriate solvent.
these ventilation openings, even partially or for
short periods. Failure to observe this specifi c pro-
hibition releases the manufacturer of the appliance
from all responsibility and immediately voids any
guarantee rights for the said appliance, because its
constructive conformity has been voluntarily com-
promised. Furthermore, the appliance is not suita-
ble for embedding and for grouped positioning with
other identical appliances.

Publicité

loading