4.4 CONNECTION OF POWER CABLE
The terminal board is on the rear panel of the ap-
pliance. Open the terminal board cover by obtain-
ing leverage with a screwdriver on the two side fi ns.
Loosen the cable gripper screw and allow the cable
to pass through it. Arrange the conductors so that
the earth conductor is the last to detach from its
terminal if the cable goes into a state of faulty trac-
tion. Connect the phase conductor to the terminal
marked with the letter "L", the neutral conductor
to the terminal marked with the letter "N" and the
earth conductor to the terminal marked with the
symbol
. Tighten the ring-nut of the cable gripper
and close the terminal board cover. The appliance
must be connected to an equipotential system
4.5 SAFETY THERMAL BREAKER
The appliance has safety thermal breaker. It pro-
tects against excessive dangerous over-tempera-
tures which could be accidentally generated inside
5. USE INSTRUCTIONS (FOR THE USER)
This appliance is not intended for use by persons
(including children) with reduced phycal, sensory
or mental capabilities, or lack of experience and
knowledge. Unless they have beengiven supervi-
sion or instruction concerning use of appliance by
a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
For fi rst use, we advise you to let the appliance to
run load-free at maximum temperature for about
one hour. In this way, any unpleasant smells due
to thermal insulation and residual work grease are
eliminated.
This appliance must be used solely for the purpose
for which it was expressly designed, i.e. cooking
whose effi ciency must fi rst be checked according
to current legal regulations. This connection must
be made between different appliances by using the
appropriate terminal marked with the symbol
The equipotential conductor must have a minimum
2
diameter of 2,5 mm
. The equipotential terminal is
at the rear of the appliance.
230V
N
L
L
2
1
the appliance. If the device is tripped, it interrupts
electrical power to the appliance and thus prevents
it from operating.
foods in the oven. Any other use is considered un-
suitable.
The appliance can be used: for all oven cooking of
deserts, pizzas, meat, fi sh, vegetables, as well as
for gratinating, and for re-conditioning cooled and
frozen foods.
When placing food in the cooking compartment,
leave a space of at least 40 mm between pans in
order not to over-obstruct air circulation.
Do not use pans with higher than necessary edges:
edges are barriers which prevent the circulation of
hot air.
Warm up the oven before every cooking operation
to obtain maximum uniformity.
Do not salt foods in the cooking compartment.
.
400V / 2N
N
L
L
2
1
EN
7