Hendi 154601 Bake-Master Mini Mode D'emploi page 6

Connecting the gas bottle
1 = main tap
2 = pressure regulator
3 = gas hose
4 = gas bottle
Attach the pressure regulator to the gas bottle us-
ing the large brass nut. Always ensure that the rub-
ber-sealing washer is present in the nut. (NB. This
Check the connections for leaks using a soap and water solution.
Igniting the gas griddle
• Place the grill grid.
• Turn the knob to the "big flame" position. Keep the
knob pressed and press the ignition button a few
Turning off the gas griddle
• Turn the knob completely to the right. The burner will go off.
Note! After turning off the burners, wait approximately 10 minutes before reigniting the burners. After
turning off the burners, always turn off the main tap on the gas cylinder and the tap on the appliance!
Cleaning and maintenance
EN
• Let the appliance cool down before cleaning
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• The grid and/or baking tray of the grill should be
cleaned regularly. Let it soak in cleaning agent
first, then use an abrasive material like a scourer
or wire brush. If you use special barbecue cleaner,
Fault
Fault
Burner will not ignite:
6
Possible cause
Defective igniter
Defective thermocouple
Dirty sparking plug
Defective pressure regu-
lator
Empty gas cylinder
Kink in gas hose
Clogged jet
rubber washer is not required for UK-type pressure
regulators). Tighten the nut well. Note that the nut
has a left-hand thread.
times until the burner is burning completely. Keep
the knob pressed in for approximately a further 10
seconds. The burner will continue to burn.
follow the instructions on the packaging.
• Clean the ventilation slots (if applicable) with a
vacuum cleaner.
• Keep inside after use.
• Let specialised personnel clean at least once a
year the burner.
• Never use a high pressure cleaner.
• Maintenance after every use: Clean the griddle.
Clean the grease holder.
Fault
Burner does not burn fully:
Possible cause
Gas cylinder is (almost)
empty
Kink in gas hose
The main gas tap on the
gas cylinder is not fully
open
Defective gas tap
Main jet clogged