Publicité
Compliance Information
FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The aircraft complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall
not be less than 20cm during normal operation. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions: (1)This device
may not cause interference.(2)This device must accept any interference,
including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :(1)L'appareil ne doit pas produire
de brouillage; (2)L'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with RSS‐102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux radiations
CNR‐102 établies pour un environnement non contrôlé. Cet équipement doit
être installé et utilisé avec une distance minimale de 20 cm entre le radiateur
et votre corps.
This equipment complies with ISED radiation exposure limits set forth for
an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.The portable device is designed to meet the requirements for
exposure to radio waves established by the ISED.
Cet équipement est conforme aux limites d'exposition aux rayonnements
ISED établies pour un environnement non contrôlé. L'utilisateur final doit suivre
les instructions spécifiques pour satisfaire les normes. Cet émetteur ne doit
pas être co-implanté ou fonctionner en conjonction avec toute autre antenne
ou transmetteur. Le dispositif portatif est conçu pour répondre aux exigences
d'exposition aux ondes radio établie par le développement énergétique
DURABLE.
部件名称
铅
汞
(Pb)
(Hg)
线路板
×
○
外壳
×
○
金属部件 （铜合金） ×
○
内部线材
×
○
其他配件
×
○
本表格依据 SJ/T 11364 的规定编制。
○：表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572
规定的限量要求以下。
×：表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T
26572 规定的限量要求。（产品符合欧盟 ROHS 指令环保要求）
30
有害物质
镉
六价铬
多溴联苯
多溴二苯醚
(Cd)
(Cr
+6
)
(PBB)
(PBDE)
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
KCC Compliance Notice
"해당무선설비는 운용 중 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할
수 없습니다 ."
"해당 무선설비는 운용 중 전파혼신 가능성이 있음"
NCC Compliance Notice
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得
擅自變更頻率、加大功率或變更原設計之特性及功能。低功率射頻器材之
使用不得影響飛航安全及干擾合法通信 ； 經發現有干擾現象時， 應立即停用，
並改善至無干擾時方得繼續使用。前述合法通信，指依電信管理法規定作
業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及
醫療用電波輻射性電機設備之干擾。
注意：
應避免影響附近雷達系統之操作。
高增益指向性天線只得應用於固定式點對點系統。
供遙控無人機類似器材遙控器之使用，應符合目的的事業主管機關有關遙
控無人機之管理規定。
設備名稱：DJI FPV Drone，型號（型式）：FD1W4K
單元
鉛
Unit
Lead
Mercury
(Pb)
線路板
－
外殼
○
排針
○
其他
－
備 考 1.〝超出 0.1 wt % 〞 及〝超出 0.01 wt % 〞係 指限用物 質 之百分比含量超出百
分比含量基 準 值。
備 考 2.〝○ 〞係 指 該項 限用物 質 之百分比含量未超出百分比含量基 準 值。
備 考 3.〝－ 〞係 指 該項 限用物 質 為排除 項 目。
EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby
declares that this device is in compliance with the essential requirements and
other relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com/
euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer,
Germany
GB Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby
declares that this device is in compliance with the essential requirements and
other relevant provisions of Radio Equipment Regulations 2017.
A copy of the GB Declaration of Conformity is available online at www.dji.
com/euro-compliance
Declaración de cumplimiento UE: SZ DJI TECHNOLOGY CO., LTD. por la
presente declara que este dispositivo cumple los requisitos básicos y el resto
de provisiones relevantes de la Directiva 2014/53/EU.
Hay disponible online una copia de la Declaración de conformidad UE en
www.dji.com/euro-compliance
Dirección de contacto de la UE: DJI GmbH, Industriestrasse 12, 97618,
Niederlauer, Germany
EU-verklaring van overeenstemming: SZ DJI TECHNOLOGY CO., LTD.
verklaart hierbij dat dit apparaat voldoet aan de essentiële vereisten en andere
relevante bepalingen van Richtlijn 2014/53/EU.
De EU-verklaring van overeenstemming is online beschikbaar op www.dji.
com/euro-compliance
Contactadres EU: DJI GmbH, Industriestrasse 12, 97618, Niederlauer,
Germany
Declaração de conformidade da UE: A SZ DJI TECHNOLOGY CO.,
○
LTD. declara, através deste documento, que este dispositivo está em
conformidade com os requisitos essenciais e outras disposições relevantes
○
da Diretiva 2014/53/EU.
○
Existe uma cópia da Declaração de conformidade da UE disponível online em
www.dji.com/euro-compliance
○
Endereço de contacto na UE: DJI GmbH, Industriestrasse 12, 97618,
○
Niederlauer, Germany
Dichiarazione di conformità UE: SZ DJI TECHNOLOGY CO., LTD. dichiara
che il presente dispositivo è conforme ai requisiti essenziali e alle altre
disposizioni rilevanti della direttiva 2014/53/EU.
Una copia della dichiarazione di conformità UE è disponibile online all'indirizzo
Web www.dji.com/euro-compliance
限用物質及其化學符號
六價鉻
汞
鎘
Hexavalent
Cadmium
Polybrominated
chromium
(Hg)
(Cd)
biphenyls (PBB)
(Cr
+6
)
○
○
○
○
○
○
○
○
○
○
○
○
多溴二苯醚
多溴聯苯
Polybrominated
diphenyl ethers
(PBDE)
○
○
○
○
○
○
○
○
Publicité
