Dometic FlyTec FT 200 Instructions De Montage Et De Service page 12

Installing the flyscreen
5.3 Pre-installing the rails
Cassette profile, skirting board and upper guide rail
The cassette profile, skirting board and upper guide rail must be assembled lying on
the ground (fig. 3, page 4) before being placed in the vehicle.
➤ Check whether the cover profile can be inserted between the C pillar and interior
fittings. You may need to adapt the contour by trimming.
➤ Guide the lower slider of the handle strip along with the cassette profile into the
skirting board.
➤ Pull the cassette and handle strip apart by a bit and then slide the cassette profile
onto the nose on the skirting board.
➤ Secure the cassette profile with the screw (M5 x 30 mm) and M5 nut on the upper
guide rail.
➤ Insert the cover for the C pillar into the cassette so that the drill holes are located
one above the other and secure the two components with three blind rivets
(4 x 8 mm with stainless steel mandrel) without riveting them (fig. 4, page 4).
➤ Secure the deflection screw M4 (fig. 5 1, page 5) to the skirting board.
➤ Fit the guide cables into the bottom and top deflection screw (fig. 5 2 and 3,
page 5).
A
NOTICE! Risk of breaking the lower plastic slider
Be careful when you are lifting and positioning the flyscreen and do not
bend or tilt the skirting board.
➤ Have two people carefully lift the pre-assembled flyscreen and position it in the
vehicle.
Adjusting the top guide rail
➤ Check whether the contour and position of the upper guide rail fit the vehicle
(see enlarged inset in fig. 7, page 5). You may need to adjust the upper guide
rail by cutting the two upper legs.
12
Dometic FlyTec FT200
EN