In Case Of Problems; Warranty - babymoov COCOON LIFE Mode D'emploi

or clean with a soft dry cloth.
Your Babydoppler Connect device is fragile and should be handled with care. The gel must be
removed after each use of the doppler. These precautions will prolong the life of your doppler.
The user must also make sure before handling it that the doppler does not present any obvious
damage which might affect its safety and the correct functioning of the device.
The typical operation time of the batteries is up to 20 days. This equipment expected service
life is 10 years. Before operating this equipment make sure to wait 10 minutes in order to let it
warm or cool and reach ambient temperature.
It is recommended to check the proper functioning of the device at monthly intervals. If there is
any proven damage, it is advisable to replace the doppler before use. Carry out regular safety
tests to make sure that the device is insulated against leakage current, including measuring
the leakage current. The recommended frequency is once every two years or according to the
directives of the country in which the device is used.
The device and accessories are to be disposed of according to local regulations after their
service lives. They can be returned to the dealer or the manufacturer for recycling or proper
disposal.
The Babydoppler Connect and its mobile application do not provide precise data on the foetal
cardiac rhythm but simply a sound recording. If the foetal cardiac rhythm is not credible, there
are other methods such as the stethoscope to check it. Only the doctor is authorised to
carry out this kind of measure.

11. IN CASE OF PROBLEMS

Generally speaking, in case of any problems switch off your doppler, remove the batteries and
unplug the cables supplied. Plug the cables back into your smartphone or tablet and your
doppler, re-install the batteries and switch your doppler back on.
If the following problems arise again when using your doppler, try to solve them by using the
proposed solutions.
Problems Possible reasons
The sound is The volume is too low.
weak The batterie is worn out.
You did not apply contact gel.
There is noise
The volume is too high.
The power is low.
Disturbance from an external signal.
There is low
The probe is wrongly positioned.
sensitivity You did not apply contact gel.
You cannot The position of the probe is incorrect.
hear or record You did not apply contact gel.
the baby's The cables are not connected correctly.
heartbeat

12. WARRANTY

Babydoppler Connect application was developed for the new generation of smartphone and
tablets and new versions of iOS/Android operating systems. BABYMOOV and LATL TECHNO-
14
Solutions
Adjust the sound volume of the
doppler.
Change the batteries.
Apply gel to the probe.
Adjust the sound volume of the
doppler.
Change the batteries.
Make sure your smartphone or
tablet is in Airplane Mode.
Adjust the position of the probe.
Apply gel to the probe.
Adjust the position of the probe.
Apply gel to the probe.
Make sure that the cables are
correctly connected.