Instructions For Safe Operation - SilverCrest SHBS 600 A1 Mode D'emploi

BB.5$B%ERRN 6HLWH  0LWWZRFK  -DQXDU    

Instructions for safe operation

~ This device can be used by children from the age of 8 and people
with restricted physical, sensory or intellectual abilities or people
without adequate experience and/or understanding, if they are su-
pervised or instructed on how to use this device safely and if they
are aware of the resulting danger. Children must not play with the
device. Cleaning and maintenance by the user must not be per-
formed by children without supervision.
~ Keep children under the age of 8 away from the device and the
power cable.
~ Only use the included original power adaptor for mains operation.
DANGER for children
~ Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags: There is a
risk of suffocation!
~ Keep the device out of the reach of chil-
dren.
DANGER! Risk of electric
shock due to moisture
~ Protect the device from moisture, water
drops and water splashes.
~ Never touch the device with wet hands.
~ The device, the battery charger and the
power unit must not fall into water or
other liquids and must not be rinsed un-
der running water.
~ If the device has fallen into water, pull
out the power unit immediately, and
only then remove the device from the
water. Do not use the device again, but
have this checked by a specialist.
~ Should liquid enter the device, have it
checked before starting the device up
again.
~ If the device is used in a bathroom, the
power unit must be pulled out after use,
as the proximity of water represents a
hazard, even when the device is
switched off.
~ Installation of a residual current device
(FI/RCD) with a rated residual operat-
ing current of no more than 30 mA is
recommended to provide additional
protection. Ask your electrician for ad-
vice. The installation should only be car-
ried out by a qualified electrician.
DANGER! Risk of electric
shock
~ Never put the device into operation if
there are visible damages to the device,
the battery charger or the cable or if the
device has been dropped before.
~ Connect the cable to the device/battery
charger before plugging the power unit
into a wall socket.
~ Only connect the power unit to a prop-
erly installed, easily accessible wall
socket, the voltage of which corre-
sponds to the specifications on the rat-
ing plate. The wall socket must continue
to be easily accessible after the device
is plugged in.
~ Ensure that the cable cannot be dam-
aged by sharp edges or hot surfaces.
~ Ensure that the cable is not trapped or
crushed.
~ When removing the power unit from the
wall socket, always pull the power unit
and never the cable.
41
GB