BWT TRIPLEX Notice D'utilisation page 8

Faucet installation
To begin installing the faucet drill a hole with a diameter of 12.5 mm (1/2'') in a suitable place on the kitchen sink or
counter.
Assemble the faucet on the countertop by first putting the rubber gasket on top of the hole and seating the faucet in
it. Put on plastic gasket, lock washer, and nut on the faucet shank sticking through at the bottom side of the hole. Screw
the nut all the way up until the faucet is firmly fixed on the countertop.
Take the blue tube, put compression nut on it, put on compression ring, then put plastic insert inside the blue tube
(in that order).
Push the blue tube into the bottom of the faucet shank ensuring the compression ring is stuck in the bottom of shank.
Screw on the compression nut in order to join the tube to the faucet.
After completing the installation the faucet must be firmly fixed on the countertop, and the blue tube firmly joined to
the threaded connection of the faucet.
Attention! Metal chips can damage the sink, it is necessary to remove them carefully after the hole is drilled. If you are
installing the faucet on a ceramic or stone fixture, use a special carbide drill bit.
This manual is the intellectual property of BWT. Copying and reprinting is prohibited. © 2017
8