Publicité
Les langues disponibles
Les langues disponibles
5. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place the griddle plate on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible materials
even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the protective film around the machine.
b) First starting:
Before the first use, remove the anti-corrosion protection fat with a cleaner. Then, it is
necessary to grease plates with oil.
During the first use, warm your machine up outside during about 30 min to evacuate
residual smokes of manufacturing oil from the metallic parts. This may emit a slight
smell for a few moments.
First cleaning
Clean the device before the first use. (See 6 Cleaning)
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the values
indicated on the descriptive plate.
- Make sure that every control knob is positioned on 0.
- Check that neither the cord nor the plug are damaged
- Unwind completely the electric power cable and connect it in a plug connected with
the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly on
the electricity network, confide its connection to a qualified person .
c) Use of device :
Elements of command and display
Command/Display
Thermostat (n°3 on picture)
Green pilot light
(n°1 on picture)
Orange pilot light
(n°2 on picture)
Never use the machine without its drip tray (n°5 on picture).
Function
On/off + Temperature setting
Machine on (pilot light on)
Machine off (pilot light off)
Machine is heating (pilot light on)
Temperature reached (pilot light off)
14
Publicité
