PLAYTIVE L217-16 Notice D'utilisation page 3

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following instructions
for use.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Scope of delivery (fig. A)
4 x Rods with player figure (1)
2 x Side walls (2)
2 x End walls with goal (3)
1 x Floor plate (4)
2 x Scoreboards (5)
8 x Adjusting rings (6)
4 x Handles (7)
4 x End caps (8)
8 x Screws with internal hex and flat washer (9)
1 x Allen key (10)
2 x Balls (11)
1 x Instructions for use
Technical data
Dimensions: approx. 30.5 x 9.5 x 50.5cm
(W x H x D)
Date of manufacture (month/year):
10/2018
Intended use
This product is intended for private use as a toy
for children over the age of 6. The product is
designed exclusively for indoor use. The game
requires skill from two players or two doubles
teams.
Safety instructions
• Warning. Not suitable for children under 36
months of age. Risk of choking because the
small balls could be swallowed or inhaled!.
• Warning. None of the packaging and
fastening materials are considered part of the
toy and must always be removed for safety
reasons before the product can be given to
children to play with.
• The product must be assembled by an adult.
Check the product before use each time
for damage or wear. The product may be
used only when in good working order and
condition!
• Children may play with the product only when
supervised by adults.
• Do not climb or clamber on the product.
• Do not place any heavy objects on the
product. The product may not be subjected to
heavy loads.
• Use the product only on an even surface.
Assembly
1. With the aid of the screws (9) and the Allen
key (10), screw the two end walls (3) to one
side wall (2) (fig. B).
Note: Make sure that the closed side of the
side wall (2) is on the outside
2. Push the floor plate (4) in (fig. C).
3. As shown in fig. D, slide an adjusting ring onto
the outside of each rod (1).
Note: Move the adjusting rings up close to the
player figures.
4. Insert the rods (1) through the openings in the
side wall (2) (fig. E).
5. Mount the side wall (2) with the aid of the
screws (9), as shown in fig. F.
6. Pin one scoreboard (5) onto each end wall
(3) (fig. G).
7. Alternate between attaching the handles (7)
and the end caps (8) to the ends of the rods
(1) (fig. H).
GB/IE/NI 5