mspa J-211 Luxury Exotic Guide De L'utilisateur page 13

NOTE: When batteries need replacement, the remote control will stop operating. Replace the old batteries within 15
minutes and the unit will be restored to its full func¬tionality.
JET Button: Use this button to activate the massage jet system. After
(1) Alter the jet nozzles in the direction to suit your needs and for best effect.
(2) Screw the jet control knob clockwise or anticlockwise to change the power
of the massage. The maximum power is air & water combo jet, the
minimum power is water jet only. There are 3 jet control knobs on the side
of the pool for J-132/J-211, and 4 jet control knobs for J-152/J-213. Every
jet control knob is to adjust the jet(s)' power of same position.
The light of the "HEATER" button displays red when the heating system is activated.
NOTE: It's normal that filtration system cannot be turned off individually when it is working.
NOTE: Filtration function can only be turned off by pressing "HEATER" button but not "FILTER" button.
The heater will be stopping heating until the current water temperature reaches the set temperature. After the set
temperature is reached, the "FILTER" button will be off and "HEATER" button shows green. After the current water
temperature drops 2°C below the set temperature, the heating system will restart and light turns into red. The "FILTER"
button will be activated automatically at the same time. The heat increase rate is maximally 1-3°F per hour.
Please note that the following conditions will lead to slow heating without heating phenomenon:
1. Environmental temperature lower than50°F
2. Outdoor wind force above Gentle breeze/F3
3. Environmental temperature lower than50°F and wind power above Gentle breeze/F3
4. Activate bubbling system when heating
5. Spa lid is not covered or improperly covered when heating
It is recommended to fill spa tub with luke warm water for quick heating and energy saving.
Spa Water Maintenance Poor water quality can be extremely hazardous to your health.
The following recommendation is helpful to keep spa water crystal clean:
A: Use filter cartridge regularly.
Screw the filter onto the water inlet (as shown in right picture)
on the spa wall by turning it clockwise.
Note: Prepare two filter cartridges for switch using, if one is in use,
you can clean and dry the spare one.
Note: Do not use filter cartridge when heating water. To avoid the filter
cartridge get damaged,
do NOT use the filter when there are children or more than two bathers in the spa. After finish using, replace the filter
cartridge.
B: Clean your filter cartridge at least one time after it continuously working for 72~120 hours. Filter cartridge should
be replaced at least once a month during peak using season.
Please make sure to unplug the power pack from the electrical receptacle before the following actions.
1. Unscrew the filter cartridge by turning it counter-clockwise.
2. The filter cartridge can be rinsed off with a garden hose and reused. However, if the filter cartridge remains soiled
and discolored, the filter should be replaced.
The MSpa filter cartridge has a lifetime of approx. 6 weeks even it's well maintained. If the paper wall in the filter still
looks new, it means the filter can be used for a few more weeks. We suggest preparing more than one filter so you
can switch between the two filters when one of them is being cleaned. Make sure the filter must be totally dry up
before use again. If dusts in the water looks obvious, change the filter frequently.
13
(2)
(1)