Publicité
Les langues disponibles
Les langues disponibles
P
o r
b
e l
m
s
Control panel/display
panel attends black
without any power at all
The spa pool is in a
strange shape
The spa is loosing air
pressure
Water Leakage
DISPOSAL
1.The marking
indicates that this product shall not be disposed with the general household waste. Please
contact your local community about collection points or ask your dealer.
2.This product contains valuable materials that can be recycled and contributed to a sustainable environment.
3.For recovery, recycling and dismantling information for this product, please visit us at www. the-mspa. com.
P
o r
b
a
b
e l
C
a
u
s
e
s
1. Power failure
2. "ON/OFF" button on control panel
isn't turned on.
Extra air pressure by strong sunshine
1. Air valve looses
2. Holes or pin splits on spa pool
1. Water is leaking between the Jet
pipes, pipes connecting the control
box and spa pool, or inlet and outlet.
2. Water is leaking from the drainage
valve
S
l o
t u
o i
n
s
1. Check if power supply is normal and well
connected to your MSpa.
2. Press "ON/OFF" button
Check the air pressure. The bath tub can get an
abnormal shape if the pressure is too high due to
strong hot sunshine. Normally this happens only if
the air pressure has been too high due to direct
sunshine.
Smart investment is to buy a spa cover at your
local MSpa dealer. This will protect the spa from
UV or pollution.
1. Drain out all the water from the spa if necessary
and possible. Try to use some Vaseline or similar
thing to grease the rubber gaskets in the air valve
and in the part to open to fit the black tube into the
panel. Fill up the spa with air.
2. Use a spray bottle with a mild detergent to be
able to see the air leak when it s coming some
small soap bubbles. Try to find the air leak on both
sides on the spa body part. Any holes or splits
within size of 10cm and not in welding seam part
can be repaired by PVC swatch and glue that is
provided in repair kit.
1.
If there is water leakage like tear drops, it is
ok for use. Please screw the pipes tightly
and correctly.
2.
Check the O-ring and replace it if
missing, again screw the pipes tightly and
correctly
16
it is
Publicité
