mspa J-211 Luxury Exotic Guide De L'utilisateur page 12

POWER PACK OPERATION
Warning: to avoid any function failure or damage, do NOT operate the spa until it is filled with water to the
minimum water mark.
It is the owner's responsibility to ensure the installation conditions are applied, all safety & warning requirements are
met. Any failure and damages that is result from dry-run, water spillage, excessive humidity, or structural loading will
void the warranty.
Control Panel:
LED Display: Once switched on, the LED panel displays
the current water temperature automatically.
1. "ON/OFF" Button: Turns in red after plug in the spa. Press to
activate power pack only when remote control is not used.
2. "TEMPERATURE" Button: To set the temperature.
3. "JET" Button: To start jetting system. The system has an auto
feature that every 30-minute operation will shut down for 1 minute. JET functions needs to be started every
30-minute manually.
4. "FILTER" Button: To activate filtration system. The light of "FILTER" button displays in green when the filtration
system is working.
5. "HEATER" Button: To activate heating and filtration system at the same time.
NOTE: The set temperature defaults to 100°Fwhen first plugged in.
NOTE: Temperature can be set from 96°F to 104°Fby every 4°Fas a circulation 100=>104=>96=>100
The control panel displays set temperature when press "TEMPERATURE" button once, and then displays current
water temperature after 1 second. When pressing "TEMPERATURE" for 3 seconds, LED starts to flash and then you
can set your desired temperature. After temperature is set, you may press the temperature button again or leave it
for 10 seconds and then it'll display current water temperature.
Remote Control:
1. "ON/OFF" Button: To activate both remote control and control box.
The display window of control box will show the same information
as what show in remote control's display window.
2. "°C/°F" Button: To select a temperature display Celsius display is
used to operate European standard control box, Fahrenheit display
is used to operate North American standard control box.
3. "TEMPERATURE▲" Button: Increase temperature
4. "TEMPERATURE▼" Button: Lower temperature
5. "HEATER ON" Button: To activate heating and filtration system at
the same time.
6. "HEATER OFF" Button: To stop heating system
7. "FILTER ON" Button: To activate filtration system
8. "FILTER OFF" Button: To stop filtration system
9. "JET ON" Button: To activate jetting system
10. "JET OFF" Button: To stop jetting system
Remote control does not have any user serviceable parts. Opening the case, except for the battery cover, may cause
permanent damage to your remote control. Keep the remote control dry and do not break it by force.
Installing Batteries
The remote control requires installing two (2) new AAA batteries (excluded).
1. Pull back the remote control's battery cover and remove it.
2. Insert the two (2) supplied AAA batteries according to the + and - marks in the battery case.
3. Push the battery cover back into place.
4. Test the unit by pressing the power key.
12
Display Window