Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
T
T
Pull the mains plug prior to transport.
The drum can be damaged during transport, e.g. on hard ground,
even when the motor is switched off. Therefore set the work depth
of the drum to position 1 during transport.
Pull out main plug.
Store unused equipment in a dry, locked place out of the reach
of children.
In case of extended storage (e.g. during winter) ensure that the
device is protected against frost and corrosion.
Before each fault clearance
− switch off device
− wait until the drum is stationary
− pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Device doesn't start
The device operates with
interruptions
Unusual sounds
Unusual vibrations
Unsatisfactory
verticulating
result
Please observe the enclosed terms of guarantee.
22
r
a
n
s
p
o
r
t
r
a
n
s
p
o
r
t
S
t
o
r
a
g
e
S
t
o
r
a
g
e
Possible cause
no power
Extension cable defect
Main plug, motor or switch defect
Protective motor switch has tripped
Extension cable defect
Internal fault.
ON/OFF button defective.
Drum is blocked
Toothed belt slips
Loose screws, nuts or other fasteners
Cutting blade damaged or dull
Work depths too deep
Lawn too high
Work depth too low
Dull blades
Discharge opening blocked
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
− thoroughly clean the device
− Treat metal parts after each use against corrosion using an
environmentally friendly biologically degradable spray oil.
Never use any grease!
To facilitate space-saving storage of the device, you can
fold down the handle hoop. Loosen the star grip screws (6) for
this purpose until the handle hoop (2) can be folded.
P
o
s
s
i
b
l
e
f
a
u
l
t
s
P
o
s
s
i
b
l
e
f
a
u
l
t
s
Remedy
Check power supply, power socket and fuse protection
Check
immediately
Have motor or switch checked by an approved electrician
or replaced by original spare parts
1. Work depth too deep
2. Drum blocked
3. Grass too long
Allow the motor to cool down approx. 15 minutes before
continuing to work
Check
immediately
Please contact the after sales service.
Please contact the after sales service.
Remove the blockage
Please contact the after sales service.
Tighten all parts; contact customer service if the noises
continue to occur.
See "Changing blades"
Set a lower work depth
Mow the lawn before thatching
Set a greater work depth
See "Changing blades"
Empty the grass catching bag and remove the blockage
G
u
a
r
a
n
t
e
e
G
u
a
r
a
n
t
e
e
extension
cable,
exchange
reduce work depth
remove the blockage
mow the grass
extension
cable,
exchange
defect
cable
defect
cable
Publicité
Chapitres
Table des Matières
