Publicité
Les langues disponibles
Les langues disponibles
LED wall light
Introduction
Congratulations on the purchase of your
new product. You have selected a high
quality product. These instructions are
part of the product and contain important informa-
tion on setup and handling. Always follow all
safety instructions. Before using this product for the
first time, verify that the voltage is correct and that
all parts are properly installed. Should you have
any questions or you are unsure about operating
the product, please contact the dealer or service
centre. Please keep these instructions in a safe place
and pass them on to third parties as applicable.
Intended use
This light is suitable for indoor and outdoor use. The light
can be fastened to any normally inflammable surface.
Parts description
Lamp glass
1
Light body
2
Nut
3
Wall plate
4
Connection housing
5
Bulb
6
Screw
7
Light
8
Mains connection lead
9
Lustre terminal
10
Membrane
11
Scope of delivery
2 Wall plugs
2 Fixing screws
2 LED bulb, GU10, 5 W
1 LED outdoor light
1 Operating instructions
Introduction / Safety information
Technical Data
Article no.:
Operating voltage:
Bulb:
Rated power max.:
Protection class:
Protection type:
Dimensions:
Safety information
RISK OF LOSS OF LIFE AND
ACCIDENT TO INFANTS AND
CHILDREN! Never leave children unat-
tended with the packaging material. The packaging
material represents a danger of suffocation. Children
frequently underestimate the dangers. Please keep
children away from the product at all times.
Danger to life from
electric shock!
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
We assume no liability for material damage or
personal injury due to improper handling or
failure to comply with the safety instructions!
Never use the light if any defects have been
identified.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse
box. Set the light switch to the „Off" position.
Prior to installation, verify that the mains volt-
age on site corresponds with the operating
voltage required for the light (230–240 V ∼).
Ensure that no cables are damaged when
installing.
3124-022L / 3463-022L
230–240 V∼ 50 Hz
230 V, GU10, 5 W
2 x 5 W
I /
IP44
3124-022L =
height approx. 29.0 cm,
Ø 9.0 cm
3463-022L =
height approx. 26.0 cm,
Ø 9.0 cm
GB
13
Publicité
