Maintenance Of The Device - Storch VarioVac 50 Mode D'emploi

Maintaining the device
ATTENTION: before carrying out any maintenance, cleaning or before replacing the filter system, always
pull the plug out of the socket.
Dust bag
Never re-use dust bags, always replace them.
Fleece filter bag (Fig. "D1")
In order to clean the fleece filter bag, it must be knocked-out in a dustbin. Where
necessary, use compressed air.
Filter cartridge (Fig. "D2" - "D3")
Clean the filter cartridge frequently using a soft brush (Fig. "D2"). For cleaning
the filter base, spray water directed from the inside to the outside (see Fig. "D3").
Re-use it again only after it has dried thoroughly. If the insert filter is soiled too
intensively or is damaged, replace it in all cases. We recommend that you always
keep a spare insert filter.
Brush
Air filter in the air outlet (Fig. "D4")
Replace the microfilter of the air being
blown out on a regular basis by pri-
sing out the grating using a coin. Then
replace the grating and make sure that
the arrow on the inner part of the grating
points upwards.
Cleaning the dirty container (Fig. "D5")
Check the amount of dirt vacuumed, especially in cases of bulky drit particles. We
recommend that you empty the dirt container as soon as it is half-full (Fig. "D5").
After vacuuming dirty fluids, the container must be emptied and washed together
with the accessories in order to avoid encrustation.
ok
55
no
Translation of the original instruction