Use - Storch VarioVac 50 Mode D'emploi

Use

Layout (Fig. "AB")
Insert the container in the frame so that the bottom edge
of the barrel engages under the front mount. The seam of
the barrel must point to the rear.
Push the bracket (E) over the rear edge of the barrel and
screw tight.
Insert the push handle into the mount (F) from above.
Then screw the bar in the mount tight.
Releasing the head of the device (Fig. "A1")
Open the device by pulling the top fastening hooks out-
wards where the device head can be removed. When
reattaching, make sure that the hooks snap in place.
Switching on (Fig. "A2")
Using the device as wet and dry vacuum cleaner
(Fig. "A2")
Switch (Fig. "A"):
to position MANUAL
Switch (Fig. "B"):
to position O = signal lamp does not light up (device without function)
to position I = signal lamp lights up (device with function)
Using the machine with an electric tool
Switch (Fig. "A"):
to position AUTOMATIC
Switch (Fig. "B"):
to position I = signal lamp lights up (device with function)
Once you have moved both switches to this position, the suction operation begins automatically together when swit-
ching on the electric tool connected and ends when the tool is switched off.
Translation of the original instruction 52