Brandt AD679XE1 Guide D'utilisation page 13

99638481_A_ML.qxp 08/12/2005
In automatic mode, the sensitivity of the hood must be adapted to the type of
hob used.
Press simultaneously on the two buttons
seconds.
According to the type of hob used, the display will show 1, 2 or 3 lines
Press on the
desired symbol (please see the table below).
To confirm your new configuration, press on the
Following validation, the hood switches over into automatic standby mode.
The symbol appears on the display when the hood is in "OFF" or automatic
standby mode. This message informs you that it is necessary to wash out your
filter cartridges.
After cleaning the filters, press once on the
automatic standby or "OFF" mode.
In the case of a kitchen heated by a device connected to a chimney (for
example a stove) the "recycling" version of the hood should be installed. Do not
use the hood without metal filters.
Suitable ventilation should be ensured for the room when the suction hood is used at
the same time as appliances using gas or another combustible fuel.
16:30 Page 13
C
ONFIGURING THE HOOD
button as many times as required until you reach the
Induction hob
Gas hob
Induction/gas combination hob
Ceramic hob
Hob with cast iron cook plates
Induction/ceramic combination hob
F
ILTER CARTRIDGE SATURATION INDICATOR
for two
button.
button when the hood is in
.
EN