Star TSP552 Mode D'emploi page 101

Two DIP switches are provided at the bottom of the printer, and can be set as given
in the table below. Be sure to set the power switch to off before changing the
settings. It is recommended to use a pointed item like a pen or flat-blade driver
screw to change the settings. The settings will become effective when the power
switch is set to on again.
ON
OFF
No. 1
Switch
1 Data receive error
2 Receive buffer size
3 Handshaking
4 Data bit
5 Parity check
6 Parity
7
Baud rate
8
Switch
1 Handshaking conditions
(conditions for BUSY)
2 <FF> Code (Star mode only)
3
Print density
4
5 Command
6 Should not be changed (should be set to on).
7 #6 pin reset signal
8 #25 pin reset signal
Appendix B: Dip Switch Setting
2 3 4 5 6 7 8
DIP-SW2
DIP-SW 1
Function
DIP-SW 2
Function
– 97 –
ON
OFF
No. 1 2 3 4 5 6 7 8
DIP-SW1
ON
Error is ignored.
45 bytes
XON/XOFF
7 bits
Yes
Even
See Table 1.
ON
Receive buffer full
Form Feed
See Table 2.
STAR
Valid
Valid
OFF
"?" is printed.
4 k bytes
DTR/DSR
8 bits
No
Odd
OFF
Offline or
receive buffer full
Cut Command
ESC/POS
Invalid
Invalid