Fitting The Plinth - Brandt UFB1000E Guide D'installation & D'utilisation

PR167
7. Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
Remove the brackets and mark a distance of 8 mm
from the outer edge of the door where the nail must
be fitted (K).
PR168
Place the small square on the guide again and fix it
with the screws supplied.
Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
8mm
Ha
Hb
8mm
K
Ha
Hb
PR167/1
9. Fix cover (Hd) on guide (Hb) until it clips into place.

Fitting the plinth

Important
For the efficient operation of the appliance, it is
important that the original ventilation grid is
used.
For an opening height dimension A=820 mm and a
I
plinth height dimension a=100 mm, the plinth may
be fitted without adjustments. The same applies to
an opening height dimension B=870 mm and a
plinth height dimension b=150 mm.
For plinth heights greater than a=100 mm, b=150
I
mm, a cut should be made in the plinth, 580 mm
wide, in the centre of the appliance position,
leaving a remaining height of a=100 mm, b=150
mm.
Attach plinth to the kitchen units.
I
Important
The plinth
must be positioned at a minimun distance of 25
mm from the door.
25
Hb
Hd
S.I.007
25
S.I.008