Grid Preparation; Door Reversal; Building The Appliance In Under A Worktop - Brandt UFB1000E Guide D'installation & D'utilisation

Grid preparation

Remove the grid from the appliance pulling it towards
you with hands.
S.I.001
Right door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure, a).
S.I.002
Left door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure, b).
To reposition the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by pushing
the clasps (a) until they click.
N.B. The grid is to be assembled after having fixed
the appliance in the niche with the brackets.
a
a
a
A
b

Door reversal

The appliance must be unplugged before starting
work. To reverse the opening direction of the door,
proceed as follows:
1. Remove the top hinge (1) taking care not to let the
door fall.
2. Remove the bottom door hinge (2).
3. Take out the plugs (3) from the holes (F) and
reinsert them in the holes (F
side.
4. Refit the upper hinge (1) on the opposite side, on
the bottom (position A).
5. Refit the door on the pin of the hige (1) in position
A;
B
6. Insert the pin of the previously removed bottom
hinge (2) in the upper hole (G) of the door,
therefore fix the hinge on the top in position B.
Building the appliance in under a
worktop
The dimensions of the recessed installation area must
correspond with those indicated in the figure.
The appliance could be inserted between two units
(a) or as an end unit (b).
23
F 1
F
1
B
3
F1
F
2
A
S.I.003
) on the opposite
1
b
S.I.004
G
a