S.I.005
Important
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
UPPER
SUPER.
D326
1. Fasten the side panel to the rear of the appliance
with the fixing brackets.
UPPER
SUPER.
E
D319
2. Fasten the appliance to the worktop or the sides,
applying the sealing strip between the appliance
and adjacent cabinet using the fixing brackets (E).
3. The appliance is equipped with adjustable support
LOWER
INFER.
4. Separate parts Ha, Hb, Hc, Hd as shown in the
LOWER
INFER.
E
5. Place guide (Ha) on the inside part of the furniture
6. Fix cover (Hc) on guide (Ha) until it clips into place.
24
S.I.006
feet. To adapt the appliance to the height of the
installation area (max 870 mm), screw in, or screw
out the feet situated in the four bottom corners.
PR266
figure.
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.
Hc
PR33
Hb
Ha
Hc
Hd
ca. 50 mm
90°
90°
ca. 50 mm
Ha