Description Of The Appliance - Brandt UFB1000E Guide D'installation & D'utilisation

compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the relevant
paragraph.
Attention: keep ventilation openings clear
of obstruction.
I
If the appliance is transported horizontally, it is
possible that the oil contained in the
compressor flows in the refrigerant circuit. It is
advisable to wait at least two hours before
connecting the appliance to allow the oil to
flow back in the compressor.
I
There are working parts in this product which heat
up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
I
Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
I
If the appliance has been transported horizontally,

DESCRIPTION OF THE APPLIANCE

➀ ➀
Air outlet duct
➁ ➁
Freezer controls
➂ ➂
Air inlet filter
➃ ➃
Comparments for storing frozen food
➄ ➄
Compartments for freezing fresh food
it is possible that the oil contained in the
compressor flows in the refrigerant circuit. It is
advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.
I
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from your
municipal authorities.
I
The materials used on this appliance marked
with the symbol
➄ ➄
➄ ➄
➃ ➃
➃ ➃
➁ ➁
➂ ➂
17
Environment Protection
are recyclable.
➀ ➀