Renkforce MH-3202 Notice D'emploi page 39

Proceed as follows:
Step 1: Starting Programming Mode
• If programming mode has not been started yet (see chapter 8. a), push the button
" " (15) briefly first. The two symbols " " (8) and "
If these two icons do not flash, push the button "
until the two symbols " " (8) and "
• Confirm the selection with the button "
at the top of the display.
Step 2: Select weekday period
• Use the button "
periods:
1 2 3 4 5 = Monday to Friday
6 7 = Saturday to Sunday (weekend)
The following programming must be performed separately for the two weekday
periods. You can use them to set different heating and saving times at the
weekend than during the weekdays Monday through Friday.
• Confirm your selection with the button "
The buttons "
4, 5 or 6.
Step 3: Select starting time and temperature for "
• If the temperature or the starting time is to be changed, push the button
" " (15) again. In the upper left of the display, the value for the temperature setting
flashes now.
• Set the desired temperature with the buttons "
• Confirm the setting with the button "
onward the set temperature applies flash then.
• Set the hours with the buttons "
• Confirm the setting with the button "
which onward the set temperature applies flash then.
• Set the minutes with the buttons "
• Confirm your selection with the button "
" (11) flash.
" (14) and " " (16) to choose between two different weekday
" (14) and " " (16) can switch on to the next period; see steps
" (14) and "
" (14) and "
" (11) will flash in the display.
" (14) or "
" (15). The numbers for the week day flash
" (15). The symbol "
" (4)
" (14) and "
" (15), the hours of the starting time from which
" (16).
" (15), the minutes of the starting time from
" (16).
" (15). The symbol "
" (16) briefly repeatedly
" (4) will then flash.
" (16).
" (5) will then flash.
39