Programming; Starting/Terminating Programming - Renkforce MH-3202 Notice D'emploi

8. Programming

If the room thermostat is switched off via the on/off switch (10), the power-LED
(13) goes out and there will be no display. Programming is not possible like this.
Switch on the room thermostat by pushing the on/off switch (10) so that it latches
and the power LED (13) lights up.
Observe:
When operating with the buttons "
lighting is activated automatically for approx. 15 seconds.
If no button is pushed within 15 seconds, the room thermostat will return to
regular operation and the display light will go out again.
a) Starting/Terminating Programming
• Briefly push the button "
the display.
• Use the button "
- Manual mode:
- Time setting mode:
- Automatic mode:
• Confirm the selection with the button "
tive selected mode.
Observe the following subchapters for this.
• To end programming, keep the button "
wait for 15 seconds without pushing a button.
" (15). The two symbols " " (8) and "
" (14) and " " (16) to choose between the following modes:
Symbol "
Symbol "
Symbols " " (8) and "
" (14), " " (15) or "
" (12) flashes
" (11) flashes
" (11) flash
" (15) to start the programming of the respec-
" (15) pushed for two seconds. Alternatively,
" (16), the display
" (11) will flash in
35