TFA 60.2528 Mode D'emploi page 13

TFA_No. 60.2528_Anleitung
BINGO - Radio-controlled alarm clock
• The device will alert you with a beep and all LCD segments will
be displayed for a short moment.
• The clock will now scan the DCF frequency signal and the DCF
symbol will be flashing on the LCD. When the time code is
received successfully after 3-8 minutes, the radio-controlled
time, the date and the DCF symbol are displayed steadily in the
LCD.
• The DCF reception always takes place at 3:00 o'clock in the
morning. If the reception is not successfully received at 3:00
o'clock, it shall be held further attempts at 4:00 and 5:00
o'clock.
• If there is no reception possible, manual initialization can be
helpful.
• Press and hold the – button for three seconds.
• The DCF symbol will be flashing.
• To end the reception, press and hold the – button for three
seconds again. The DCF symbol disappears.
• There are three different reception symbols:
flashes - reception is active
stays - reception is good
no symbol - reception is deactivated/turned off
24
31.03.2014 09:55 Uhr Seite 13
BINGO - Radio-controlled alarm clock
• If the clock cannot detect the DCF-signal (for example due to
disturbances, transmitting distance, etc.), the time can be set
manually. The clock will then work as a normal quartz clock.
(see: Manual settings).
Radio-controlled time reception
The time base for the radio-controlled time is a caesium atomic
clock operated by the Physikalisch Technische Bundesanstalt
Braunschweig. It has a time deviation of less than one second in
one million years. The time is coded and transmitted from Main-
flingen near Frankfurt via frequency signal DCF-77 (77.5 kHz) and
has a transmitting range of approximately 1,500 km. Changeover
from summer time or winter time is automatic. In Daylight Saving
Time is shown on the LCD. The quality of the reception
depends mainly on the geographic location. Normally there
should be no reception problems within a 1,500 km radius
around Frankfurt.
Please take note of the following:
• The recommended distance to any interfering sources like
computer monitors or TV sets is at least 1.5 - 2 meters.
25