Topcom BPM ARM 3301 Manuel D'utilisateur page 9

mmHg
ERROR
11 Memory
mmHg
When the batteries are installed, the data in the memories
will not be lost even when the Blood Pressure Monitor is
switched off.
4. When the measurement is
completed, systolic, diastolic
and pulse will be shown
simultaneously on the LCD
screen.
When a mistake was detected dur-
ing measurement the Error mark
appears on the display
The BPM 3301 has 3 Memory zones. Each can store
up to 30 measurements including the date and time.
The result will be stored automatically in the selected
Memory Zone after the measurement.
Select the desired Memory Zone before measurement,
by pressing the SET button repeatedly.
To recall measurement results:
• Press the SET button repeatedly to select the
desired memory zone.
• Press the MEMORY button to see the last
measurement result.
• Press the MEMORY button repeatedly for prior
values stored.
• To stop reading the data, press the START/STOP
button to switch back to normal time.
To erase all data from one memory zone:
• Press the SET button repeatedly to select the
desired memory zone.
• Press the MODE and SET button simultaneously
to erase all data from the selected memory zone.
TOPCOM BPM Arm 3301
9