Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
on the display. Then, the setting is completed and the display will return to sta-
ting the current room temperature.
•
The thermostat built into the Solis Silent Heater measures the temperature in the
room and starts the heating function. Once the set room temperature is reached,
the heating function stops. If the room temperature drops below the set value,
the heating function will restart.
•
Switching off the appliance will delete the programmed temperature.
•
Note : Please bear in mind that the thermostat can only measure the tempera-
ture immediately around the appliance.
Should you simultaneously measure the temperature with a thermometer some
distance away from the heater (f. e. at the other end of the room), the readout
on the thermometer might be a few degrees below the value displayed on the
heater. Should the thermometer f.e. be placed directly above the heater, the va-
lue might be even higher than stated on the heater, as warm air rises up. The
heating function of the Solis Silent Heater always corresponds to the tempera-
ture measured and displayed by the thermometer built into the heater.
4. TIMER button
•
Once you have turned the Solis Silent Heater on with the ON/OFF button, you
can use the TIMER button to determine operation time of the appliance. When
you press the TIMER button once, either the factory setting „0" or the most re-
cent setting will light up in the display. Now, press the TIMER button (or hold it),
until the number of hours appropriate for you lights up. You can perform any
setting between 1 and 24 hours, at intervals of 1 hour. Not pressing the button
for 5 seconds will save the setting, the number of hours will not flash on the dis-
play any longer. The current room temperature will reappear on the display.
•
When the set operation time has elapsed, the appliance will deactivate the hea-
ting function and return to standby mode.
•
As long as the TIMER function is activated, the display will show a clock symbol.
•
Switching off the appliance will delete the TIMER setting.
47
Publicité
Table des Matières
