SOLIS 683 Mode D'emploi page 44

▲
M O U N T I N G T H E H E AT E R
W A L L M O U N T I N G
• Minimum distances when mounting the appliance to a wall:
To next wall: at least 25 cm
To floor: at least 15 cm
Upwards: at least 45 cm
• Please only use the provided wall mount.
• Please keep to the minimum distances men-
tioned above to guarantee optimal perfor-
mance and adequate air circulation and to
prevent overheating.
• The heater must only be mounted to walls not
sensitive to heat.
Step 1: Removing the wall mount from the appliance backside
• Turn out the two small screws at the upper end of the vertical mounting bar using
a screwdriver. Push the upper and lower end of the two small holding struts (pre-
viously held in place by the screws) against each other. Now, you can remove the
holding struts from the slots.
• Pull the two lower mounting struts from the slots and remove the wall mount
from the appliance backside.
44
1
3
2
3
4
4
25 cm
1 Upper holding struts
1
2 Vertical mounting bars
3
3 4 bores for the wall
2
4 Lower holding struts
3
45 cm
15 cm
with one small screw
each
screws