Storch 62 13 40 Mode D'emploi page 83

Assembling the tool
Fit the dust bag (9) if necessary.
Mounting the pad
1. Place the backing plate (5) with the screw in the centre (6)
(fig. 1);
2. slightly turn the backing plate (5) until it is fixed to the
screw as in fig. 2;
3. tighten the screw using the supplied wrench (7) (fig. 3).
Do not tighten the backing plate screw if it is in the wrong
position (fig. 4);
4. to remove, follow the same procedure in reverse order.
Replacement of the abrasive paper assembly:
- Press the abrasive paper into the pad (10) ensuring that the
holes in the paper coincide with extraction holes in the pad.
Disassembly:
- Used abrasive paper can be removed by simply tearing them
off;
- new velcro abrasive paper it's mounted (see "Assembly")
Sanding pad replacement
Replace damaged sanding pad immediately. Opti-
mal results are achieved only using original accessories.The
assembly of a sanding pad with incorrect dimensions can cau-
se excessive vibrations which are not allowed for the machine.
- Unscrew the screws (7) on the pad;
- reverse the procedure when fitting the pad.
Start the tool and check that there are no unusual vibration,
no dismatching movement of the abrasive disc. Otherwise
switch-off the tool immediately and eliminate the cause.
Translation of the original instruction
83