Starting Up - Storch 62 13 40 Mode D'emploi

Starting up

WARNING:
Pay attention to the mains voltage! The mains voltage must
correspond to the voltage indicated on the technical data iden-
tification place (1).
DANGER:
You must remove the plug from the socket before replacing
accessories or performing any work on the electrical tool.
Before starting the tool:
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of
having been damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction
booklet;
- the power supply and socket outlet can support the load
reported in the table and that indicated on the tool
identification plate reproduced;
- the power supply cable and plug are in perfect condition;
- the ON/OFF (2) switch works properly though with the
power supply disconnected;
- all the parts of the tool have been assembled in the proper
manner and that there are no signs of damage;
- the ventilation slots (6) are not obstructed;
- the tool must be connected to a suitable and efficient
aspiration device.
Translation of the original instruction
82