Transmitter Controls - Reely ROAD Big Tiger II 4WD RtR Notice D'emploi



7. Transmitter Controls

1 Telescopic antenna
You can unscrew the telescope antenna for transport if
desired.
2 Eyelet for carrier strap
3 "CH1 Rev" slide switch for CH1/reverse (steering)
If the steering responds in exactly the opposite direction
to the movement of the steering dial (8), you can reverse
the movement using this slide switch.
4 "CH2 Rev" slide switch for CH2/reverse (drive)
This inverts the response of the motor (forward/reverse)
to the throttle (13).
5 Three LEDs (red, yellow, green) for battery status
indication
If all three LEDs are lit, the batteries are full.
If the green LED goes out (only the red and the yellow
LEDs are lit), the batteries are low and should be
exchanged soon.
If only the red LED is still lit, the batteries/rechargeable
batteries are spent and must be exchanged for new
ones.
6 Exchangeable crystal
A crystal with the same frequency must be inserted in
both the transmitter and in the receiver. Transmitter
crystals are generally marked with "TX", receiver
crystals with "RX". Do not mix up the two crystals!
7 On/off switch
Use this slide switch to turn the transmitter on or off. If the slide switch is moved towards the steering dial (8), the
transmitter is switched on. Never turn the transmitter off when the vehicle is in operation!
8 Steering dial
9 Trim control for steering
Use this trim control to set the straight driving alignment of the vehicle. With the vehicle at a standstill, adjust the
front wheels so that they sit in a straight position. The exact setting of the straight driving alignment is carried out
later when driving the vehicle.
10 Trim control for neutral position of the drive
To ensure that the vehicle stops when you let the throttle lever go (13), you can set the exact neutral position with
this trim control.
30
1
2
8
6
7
15
12
3 4 5
9
10
11
13
14
Figure 1