MRA 4025066161829 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Screen
1 Holders, 1 pair
4 Rubber screw-nuts M5
4 Plastic washer, 12x5x0.5mm
4 Fillister head screws M5x20mm
4 Spacer sleeves 3mm
4 O-rings 4.5x1.5
1 Protective edge strip, clamping
sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the original windscreen.
3. Remove the original windscreen retaining plates (image 1).
4. Install the retaining plates included in the delivery (11311) with the original Allen screws in
the desired position on the motorcycle (image 2).
5. Tighten the Allen screws and place the rubber screw-nuts (10629) into the retaining plates
(image 2).
6. Then, push the Allen screws with the plastic washers (10635) through the 4 holes on the
MRA screen. From underneath, place the spacer sleeves (10872) with the O-rings (10992)
against them (image 3).
7. Position the screen and tighten the fillister head screws.
8. As in image 4, fit the protective edge strip onto the screen. Cut off the rest if required.
9. Push the clamping sleeves over the ends of the protective edge strip and lightly compress
these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Ninja650 2017-
Article No..
--- Allen key 3mm, 4mm
11311
10629
10635
10673
10872
10992
---
3
Required tools