WAGNER W 550 Mode D'emploi page 21

W 550
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
•
Set the container on a sheet of paper, pour in the prepared coating material and screw
the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun (Fig. 3).
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
•
Pull the trigger guard. The W 550 has a two-stage trigger guard. In the first stage the
turbine is started. If the trigger guard is pressed further, the material is transported.
•
Adjust the spray setting on the spray gun.
Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
Selecting the Spray Setting
Fig. 4 A = horizontal flat jet 
Fig. 4 B = vertical flat jet
Fig. 4 C = circular jet
Adjusting the desired Spray Setting (Fig. 5)
With the union nut (2) slightly unscrewed, turn the air cap (1) to the desired spraysetting
position (arrow). Then tighten the union nut.
WARNING!
Adjusting the Material Volume (Fig. 6)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left
+ turn to the right 
for horizontal surfaces
for vertical surfaces

for corners, edges and hard-to-reach surfaces

Danger of injury! Never pull the trigger guard while adjusting
the air cap.
lower material volume

higher material volume
GB
15