WAGNER W 550 Mode D'emploi page 19

W 550
5. Service
a) Have your tool repaired only by qualified specialist personnel and only with
original spare parts. This ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced by the manufacturer or it's
service agent or a similarly qualified person in order to avoid a safety hazard.
Safety Instructions for Spray Guns
•
You may only spray coating materials such as paints, varnishes, glazes, etc. with a flashpoint
of 21°C (32°C in UK) and higher without additional warning. (German classification of
coating material is hazard classes A II and A III, see material tin.)
•
The device may not be used in workplaces covered by the explosion-protection
regulations.
•
There must be no sources of ignition such as, for example, open fires, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the
vicinity during spraying.
•
Do not spray any substances whose hazard potential is not known.
•
Before working on the spray gun remove the power plug from the socket.
•
Do not use the spray guns to spray flammable substances.
•
The spray guns are not to be cleaned with flammable solvents which have a flashpoint
under 21°C.
•
Caution against dangers that can arise from the sprayed substance and observe the
text and information on the containers or the specifications given by the substance
manufacturer.
Recommendation: Wear a breathing mask and safety glasses when spraying.
CAUTION - DANGER OF INJURY!
Never point the spray gun at yourself, at other people or at animals.
•
When working with the W 550 indoors as well as outdoors ensure that no solvent vapors
are sucked in by the spray gun.
•
When working outdoors, be aware of the wind direction. Wind can carry the coating
substance across greater distances - thus causing damage. When working indoors, provide
for adequate ventilation.
•
Do not let children handle the device.
•
Never open the device yourself in order to carry out repairs in the electrical system!
•
The units may only be used with a functional valve.
(Fig. 1, item 11) do not operate the unit further! Dismantle and clean the ventilating
hose, valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun.
With original WAGNER accessories and spare parts, you have the
guarantee that all safety regulations are fulfilled.
If paints rises in the ventilating hose
GB
13