Table des Matières
Publicité
SETTING DIFFERENTIAL FEED
Set by simply moving the differential feed control dial in the direction desired, referring to the chart below.
The adjustment can be made between 0.7 (negative effect) and 2 (positive effect). These settings
give the best ratio of feeding.
For normal sewing without differential feed, set the dial on 1.
The lever can be reset even while sewing.
EFFECT AND APPLICATION
TYPE OF FEEDING
Waver-free seams,
Positive differential feed
Gathering
No differential feed
Neutral feed
Pucker-free seams
Negative differential feed
FOOT PRESSURE REGULATOR
Presser foot pressure has been correctly set at the factory, so you do not need to adjust it for most
ordinary sewing. If adjustment is necessary, turn the foot pressure regulator to a higher number to
increase or to a lower number to decrease pressure.
SEWING WITH EXTRA HEAVYWEIGHT FABRIC OR MULTIPLE
LAYERS OF FABRIC
A wide range of fabric can be sewn on this machine. It is recommended that you tighten the screw
as illustrated when sewing with extra heavy weight fabrics or multiple layers of fabric. Open the
working table to make adjustments.
When sewing with light or normal weight fabric, loosen the screw on the cutter release mechanism,
located below the slot in the needle plate. Or turn the overedge cutting width dial to adjust cutting
width for your fabric.
The machine is set at the factory for normal weight fabric.
I
Illustration *
: Differential feed control dial
II
*
: Increase
III
*
: Decrease
IV
*
: Tighten
V
*
: Loosen
VI
*
: Cutter release mechanism screw.
48
FEED RATIO REAR:
SETTING
FRONT
1-2
|-----------|----------------|
1
|--------------|-------------|
0.7-1
|-----------------|----------|
Publicité
Table des Matières
