Singer Stylist II Serger Manuel D'instruction page 45

Table des Matières

ADJUSTING STITCH LENGTH

Turn the Stitch length dial until the required length is obtained.

ADJUSTING OVEREDGE CUTTING WIDTH

Overedge cutting width can be adjusted from 0.16 inches to 0.28 inches (4 to 7 mm) by simply

turning the Overedge cutting width dial to accommodate your fabric.

Decrease the cutting width by turning it towards 5 if fabric edge curls while sewing. (Fig. 1)

Increase the cutting width by turning it towards 7 if loops hang off the edge. (Fig. 2)

Stitch finger (B)

Loops may hang off the edge when you sew with lightweight fabric using three threads (right

needle only) and setting the width dial at 4 – 5 (Fig. 3). In such a case, change the stitch finger

(A) to (B) to get proper stitching. (Fig. 4)

Illustration

: Stitch length dial

: Overedge cutting width dial

III

: Stitch finger (B)

: Cross section view of stitch finger

Fig. 1

Fig. 2

(B)

(A)

Fig. 3

Fig. 4

Table des Matières

14j250