Rittal CMC III Notice D'installation Et D'utilisation page 7

EN
1 Notes on documentation
This installation and short user guide is intended for experienced trained specialists and contains only
the most important information concerning the assembly, installation and function of the CMC III
Vandalism Sensor (subsequently called vandalism sensor).
1.1 Associated documents
CMC III Vandalism Sensor assembly and operating instructions.
It is available at www.rittal.com and contains the complete application-relevant information and techni-
cal data for the vandalism sensor with regard to:
– Further assembly possibilities
– Functions
– Configuration possibilities
– Detailed operating instructions
– Troubleshooting
2 Safety instructions
– Assembly and installation of the vandalism sensor may only be performed by experienced trained
specialists.
– The vandalism sensor housing must not be opened.
– The vandalism sensor must not come in contact with water, aggressive or inflammable gases and
vapours.
– The vandalism sensor must only be operated within the specified environmental conditions (see
section 3.4).
3 Product description
3.1 Functional description
The vandalism sensor registers vibrations in the X, Y and Z axes within the server enclosure. It signals
any changes to the connected CMC III PU. The vandalism sensor has an identification that allows it to
be detected automatically by the CMC III PU.
3.2 Proper use
The vandalism sensor is used only to monitor switch cabinets and server enclosures. It may be used
only together with the CMC III PU. Any other use is not permitted.
3.3 Scope of delivery
– CMC III Vandalism Sensor
– Accessories supplied loose (fig. 1)
– Installation and Short User Guide
3.4 Operating conditions
The vandalism sensor may only be operated under the following operating conditions:
Operating condition
Temperature operational range:
Humidity operational range:
Degree of protection:
Rittal CMC III Vandalism Sensor
Notes on documentation, Safety instructions, Product description
CMC III Vandalism Sensor
0 °C to +55 °C
5% to 95% relative humidity, non-condensing
IP30 in accordance with EN 60 529
EN
7