Matrix BMS 1400-3 Traduction De La Notice Originale page 34

Problem
The engine stops.
The tool starts, but the
engine has little power.
The tool does not start, or
starts, but does not run.
Engine runs irregularly.
Excessive emission of
smoke.
34
Possible C ause
Incorrect adjustment of
carburetor
Incorrect adjustment of choke
lever
Air filter is dirty
Incorrect adjustment of
carburetor
Incorrect procedure when
starting
Incorrect adjustment of
carburetor
Spark plug is full of soot
Gasoline filter plugged up
Incorrect air gap at spark plug
Spark plug burnt down
Incorrect air gap at spark plug
Spark plug burnt down
Trouble shooting
Have the carburetor adjusted by
a technician.
Switch to
Remove the filter made of
foamed plastic, wash in soapy
water and reinsert when dry.
Have the carburetor adjusted by
a technician.
Observe the instructions in
"Starting when Engine is Cold
1-8".
Have the carburetor adjusted by
a technician.
Clean the spark plug, correct the
air gap, or replace the spark plug.
Replace gasoline filter
Clean the spark plug, correct the
air gap, ideal is 0,25"/0.63 mm, or
replace the spark plug.
Have the carburetor adjusted by
a technician.
Empty the tank, fill in the correct
mix: 2-stroke mix 40:1.